

What you’ll need:
- A – (4) Four 1.5 x 1.5″ pieces cut to 16″each
- B – (2) Two 1.5 x 1.5″ pieces cut to 6 3/16″each
- C – (2) Two 3.5 x 1″ pieces cut to 9 1/4″ each
- D – (1) One 3.5 x 1″ piece cut to 13 7/8″
- E – (1) One 3.5 x 1″ piece cut to 12 1/4″
- One IKEA Bekvam Stool (here)
- (2) Two eye hooks (here)
- (1) Swivel Eye Hook (similar here – we found one cheaper at the HD store)
- 2 ft of thick nylon rope
- 1 1/2″ wood screws
- 2″ wood screws
- Wood glue (optional)

- Attach two B pieces to the four A posts. We recommend starting with a very thin layer of wood glue on the ends of the B pieces to help prevent them from spinning. Fit B piece 9″ up from the bottom of A posts and let glue set for 5-10 minutes. Once the glue is mostly dry, drill a pilot hole where you will connect B to A and then screw in using one 2″ screw on each side.
- Attach two C pieces to the top of A posts on each panel you just created. These C pieces will become the side railing of your finished tower. Use two 1 1/2″ screws on each corner connecting the C piece to your A pieces. (Drill pilot holes first)
- Attach D to create the front of your tower. Use two 1 1/2″ screws on each side to attach D to the top of rear A posts combining your two sides. This becomes the front bracing point where the child will lean. (Drill pilot holes first)
- Attach E below D to close off the opening at the front. The bottom of the E panel will come up 6.5″ from the bottom of the A post. Use one 1 1/2″ screw on each side of the E piece. (Drill pilot holes first)
- Attach entire piece you have created to the top piece of the IKEA Bekvam stool. You will need to remove the top piece of your stool if it is already built. We recommend using a thin layer of wood glue on the bottom of each A post before screwing them together. Use four 2″ screws to attach each post (one screw per post). (Drill pilot holes first)
- Follow the IKEA instructions to build the stool. If you stool is not yet built, follow the instructions that came with it to build. The tower piece you created will not get in the way of building the stool.
- Attach your rope. Many samples we saw used a dowel to close off the back (where the stool steps are). This dowel becomes a permanent piece that cannot be removed (child would duck under it to get into the tower) and we decided we preferred being able to open and close the Learning Tower. To do the same, drill two pilot holes where you want your rope to be on your back A posts and then screw eye hooks into either side. Loop rope through one eye hook and through your swivel eye hook clasp and tie a sturdy knot.
Notes:
- We made the entire learning tower slightly smaller than the stool top in order to allow Grayson to be snug in there. He still has plenty of room around him but he tends to get really excited and bounce around and we felt more comfortable having the tower part in from the edge of the stool to avoid any possible tipping scares. You can make this a little wider to go right to the edge of the stool top but you would need to adjust your measurements accordingly.
- When drilling a pilot hole, use a drill bit that is approximately 1/4″ smaller than the screw you will be using. This will allow your screw to bite (grip) the wood. Drilling the pilot hole will prevent splitting the wood which would be likely if you were to just put the screw directly into solid wood.
*All photos in this post can be clicked on to enlarge and see further detail.*





















